All our solutions

Installation

Boiler installation

Installing or replacing a boiler requires defining what the new system must provide. The old appliance’s rated capacity is not, by itself, a specification for the next one.

Estimate my installation
Heat demand → retained network → boiler and controls
Heat demand → retained network → boiler and controls
  1. Heat demand
  2. retained network
  3. boiler and controls
Schematic illustration. The actual installation must be assessed on site.

Define the functions

State whether the boiler will provide heating alone or hot water as well. Describe rooms, retained emitters and changed property use. Insulation work, an extension or different hot water demand can change the project requirements.

Check the whole system

Assess fuel, connections, exhaust and controls alongside existing network condition. Adaptation may be needed even when the new appliance looks similar. Ask the proposal to identify reused and replaced elements rather than assuming equivalence from appearance or dimensions.

Compare complete scope

The quotation should specify supply, removal, adaptations, commissioning and documents handed over. Check intended controls and operating explanations too. Comparing only the boiler price leaves out some work needed to make the installation usable.

Other services from our group